Laboratory Type Compression Moulding Press

'Santec' now presents a new series of laboratory presses incorporates all latest features required to test the various materials for Research & Development. These presses are designed to be low maintenance, low noise & need minimum floor area.

Standard Features

• A specially designed heating system ensures a high uniformity of temperature of the plates. For this reason the press is ideal for moulding rubber & plastic sheets or samples for laboratory tests. Digital PID controllers - FUJI (Japan) make provided for accurate temp. measurements.
• The press can also be successfully used for moulding small series of rubber or plastic parts for mass production too. Press structure is very rigid & can work in 3 shifts.
• The press is covered from all three side except front side for loading & unloading of mould inside the press. At the front side a safety photo guard is fixed for operator's safety.
• 4-pillars type construction hence better alignment.
• PLC with display unit, so press is easy to operate.
• Automatic press control device for programming an automatic production cycle by inserting upto 5 degassing cycles & curing time for moulding. At the end of the programmed time, the press automatically opens & a beeper signals the end of the cycle.

Optional
Heating platens fitted with water recirculation circuit for the moulding of thermoplastic materials is also provided on customer's request.

Safety Features

• Emergency Push Button
• Photo Safety Guard at Front Side.

Standard Specifications
(Custom built presses can also be built)

Capacity	12 Tons	20 Tons	30 Tons
Clear Platen size	200 x 200 mm	300 x 300 mm	350 x 350 mm
Max. Stroke	200 mm	250 mm	300 mm
Daylight	200 mm	250 mm	300 mm
Temperature	250° C	350° C	Upto 400 degree cel.
Power Supply	415 V/ 380 VAC 50 Hz, 3 Phase	415 V/ 380 VAC 50 Hz, 3 Phase	415 V/ 380 VAC 50 Hz, 3 Phase
Electrical Power	3 H.P.	5 H.P.	5 H.P.

Request a Quote